dhcpcd-discuss

Greetings,

im trying to get  ipv6 to propagate from an x86 router ive configured to
2 interfaces.  So far on the router i have:

interface eth2
  ipv6rs                         # enable routing solicitation get the
    ia_na 1                        # request an IPv6 address
      ia_pd 2 eth2/0 eth1/1 eth0/2   # request a PD and assign it to
      eth1

this assigns a proper ipv6 to my uplink interface (eth2) during dhcp
solicitation 2605:e000:9fc0:28:68d7:19f0:5ed0:a740

this also assigns eth0 and eth1 
2605:e000:130a:101:2000::1 
2605:e000:130a:101:1000::1

respectively, however from a desktop connected to 1000::1 I cant seem
to get ipv6 traffic to flow properly...im not sure if my prefixes are
correct?

the desktop is 2605:e000:130a:a:1d7a:7b07:5fb:8d45 prefixlen 64
however my router interface 1000::1 and 2000::1 are prefixlen 68...

the desktop shows the following routes:
2605:e000:130a:a::/128         [::]                       Un   0   2
0 eth0
2605:e000:130a:a:1d7a:7b07:5fb:8d45/128 [::]                       Un
0   6    14 eth0
2605:e000:130a:a::/64